XSM: Limiting users and group of users to change the settings done by SUPER group

XSM: Limiting users and group of users to change the settings done by SUPER group

$SM_MANAGE_SFG_GLOBALS_SEEPS is a Task Keyword in TRACL that controls which user can change the settings that already done by the super group. List the users and group of users are allowed to change the setting and leave "out" users and group of users that are not allowed to change the setting.
 
In the example below, "only" SUPER.*, 100,21 and 100,213 are allowed to change the setting.
TRACL Example:
TASK $SM_MANAGE_SFG_GLOBALS_SEEPS ACL SUPER.*      !only SUPER user can change the setting.
! you can also add users to the list on multiple lines if needed.
                                      100,21     ! SEC.USER6                             
                                      100,213    ! SEC.USER7
For further information refer to the XYGATE® Safeguard Manager Reference Manual.

If this article did not provide a solution, please open a case with our support team by sending an email message to support@xypro.com.

    • Related Articles

    • XSM: XSM_REPORT not showing an audit file name.

      Logon to the system at issue via the XSM GUI and perform a valid Safeguard operation in order to generate XSM audit records. Check the SMCONF file to make sure that an AUDIT file location has been specified. If one has been configured, do a FILEINFO ...

    • XSC proper cipher suite (Schannel) requirement settings

      Based on the XHE settings for HE SSL Client , you can sort the ciphers needed on your PC. For example XHE configuration has the below settings and you can find the right algorithm from the below table: Example: How to configure XHE Client for SSL ...

    • XSM GUI: Safeguard audit log shows super.super instead of actual user ID

      The XSM audit trail contains the UserID used to logon to the GUI. For example, XYPRO Support \NODE Blank Date produced: 05-JUL-2018 14:19 Page: 1 Criteria:2018-07-05 08:28 to 2018-07-05 08:33 File:$SYSTEM.XYGATESM.AUDIT YYYY-MM-DD HH:MM:SS Command IP ...

    • XMA How To Change Ownership On The Existing Installation

      The following methods are available to change the ownership of an XMA environment. Method #1 - Re-Install XMA Procedure: Refer to Chapter 1 " Installing XMA " in the XYGATE Merged Audit (XMA), User's Guide and Reference Manual Method #2 - ...

    • XSM: How to create a report of users not logged on in over 90 days.

      In releases v1.65 and greater: 1. Launch the XYGATESM GUI 2. Select the Reporting tab 3. On the tree, right click on the name of the node you are currently connected to 4. Choose Add new report 5. From the list, choose the Last Logon - Greater than ...