XOS: File system error 201 from procedure OPEN, file <Node>.$XOS.#ZEEP (Process File)

XOS: File system error 201 from procedure OPEN, file <Node>.$XOS.#ZEEP (Process File)


FIX:

Restart safeguard with a fully specified IN/OUT/TERM that directed to a permanent terminal.

Example:

TACL>$SYSTEM.SYSxx.OSMP/NAME $ZSMP,CPU 0,NOWAIT, in $ZHOME,out $ZHOME,pri 199,TERM $ZHOME/1

TACL>status $zsmp

System \<Node>

Process             Pri PFR %WT Userid  Program file               Hometerm
$ZSMP       1,432   198 P   011 255,255 $SYSTEM.SYS05.OSMP         $ZHOME
                        Swap File Name: $SYSTEM.#0
$ZSMP    B  0,344   198 P   001 255,255 $SYSTEM.SYS05.OSMP         $ZHOME
                        Swap File Name: $SYSTEM.#0
  

If this article did not provide a solution, please open a case with our support team by sending an email message to support@xypro.com.


    • Related Articles

    • XOS: Audit File Error 45 - Missing Sequence Numbers

      If a disk file name is specified for the AUDIT and no disk file exists, the file is created with the default format of type E, rec 4000, block 4096, primary extent size 300 pages, secondary extent size 300 pages and maxextents set to 16. When an ...

    • XOS: Process reports error 40 timeouts

      If you are running XYGATEOS, you must either install the T9050 SPR, or get a patch for XOS that eliminates a spurious processhandle_decompose_ call. SPR T9050 T9050H02^AUY T9050J01^AUZ T9050H02^AVC T9050J01^AVE Advise the customer to install HP T9050 ...

    • XOS: \UNKNOWN appears in XOS AUDIT log

      Check the following entries in the OSACL. EXPLICIT_NODES OFF and REMOTE_PROCESS_LOOKUP OFF EXPLICIT_NODES should only be turned ON if you have a fast expand network and fast system at each node. Turning both ON could affect performance. It is ...

    • XOS: Why am I seeing \UNKNOWN in the XOS Audit Report?

      Below are two possible reasons "\unknown" is seen in a XOS Audit Report for node name: A. When the EXPLICIT_NODES is OFF and you try to execute a FUP program on \one node to purge a file on another you see \UNKNOWN on the SUBJECT-SYSTEM field as ...

    • XAC: Error 580 opening audit file

      The maximum audit file size must be less than 4GB. Audit file sizes larger than 4GB create a File System Error 580 OPEN or FILE_OPEN error. If you are unable to locate the solution needed or need additional assistance please Click Here to open a case ...