XMA: When does write access required after XMA installation?
If the XMA installation has been done and the XMA catalog has been created "READ" access to the system catalog will be sufficient. Write Access will be needed again If the customer wants to uninstall XMA or change the XMA Catalog location.
If you are unable to locate the solution needed or if you need additional assistance please Click Hereto open a case from our Customer Care Portal.
Related Articles
XS1: MongoDB configuration steps for XS1 installation
Summary: 1. create the user "xs1.admin" 2. create the db "XYGATE_SecurityOne" 3. create the collection "xma" 4. create the user "xs1.owner" with read/write access to the db XYGATE_SecurityOne 5. if needed, modify the mongod configuration file ...
XMA: How to modify FILTERS file to write to two ArcSight (LAF) devices simultaneously
Note: LAF file and filter names will be referenced as LAFxxx or xxx, where: xxx = ARC (XMA 2.57 and earlier versions) CEF (XMA 2.60 and later versions) If the LAF macro has already been run once to install the ArcSight adapter, the user can do the ...
XMA: Is additional licensing required to install a log adapter in order to write data to a SIEM?
Whether additional licensing is required by XYPRO depends on the log adapter to be installed. The LAFRSA, LAFRST and LAFXS1 adapters require additional licensing, while the LAFCEF adapter does not. If you are unable to locate the solution needed or ...
XMA: Saveabend files are not being created by mover abends
1. Does the security of the XYGATEMA (XMA) installation disk volume or subvolume allow CREATE access to the XMA installation owner? Check for any Safeguard volume or subvolume ACLs or XYGATEOS rules that prevent WRITE or CREATE access for the XMA ...
XMA: Error 73
This is a known issue that has been addressed in our current XMA Version 2.65. We therefore recommend upgrading to XMA 2.65 in order to address this error. Softdoc entry for this issue: * XMA-1329 Addresses a latency issue when retrieving messages ...