XMA: Pathway 1163 Licensing error on startup

XMA: Pathway 1163 Licensing error on startup

FIX:

Identify the XYGATEOS ACL FOGROUP  that restricted access using XOS_EXPLAIN.

Logon as the owner  of the XYGATEOS installation.

TACL> VOLUME $<Volume>.<XYGATEOS Installation Subvolume>
TACL> RUN XOS INSTALL
TACL> XOS_EXPLAIN
Access check:READ FILE $SYSTEM.ZPATHWAY.ZLICSA58 $SYSTEM.SYSTEM.PATHMON
.
.
Access result - NO using FOGROUP SECURE-ZPATHWAY

Access check:READ FILE $SYSTEM.ZPATHWAY.ZLICSA59 $SYSTEM.SYSTEM.PATHMON
.
.
Access result - NO using FOGROUP SECURE-ZPATHWAY


Using the identified FOGROUP, use the XYGATECF GUI to modify the permissions in the FOGROUP to allow Read and Execute access to the $SYSTEM.ZPATHWAY.ZLICSA58 and $SYSTEM.ZPATHWAY.ZLICSA59 files for the required user. 
 
* If you use the HOST XYGATEOS XOS_EDIT_ACL macro, refer to the XYGATEOS Reference Manual for complete instructions.

If this article did not provide a solution, please open a case with our support team by sending an email message to support@xypro.com.

    • Related Articles

    • XMA: Cannot Start $XMA Pathway - Startup attempt fails with no errors

      Check the HOMETERM value in the MACONF file. The MACONF file is found in the XYGATEMA installation subvolume. The HOMETERM value must be a valid / existing home terminal process name. Sample MACONF file: PATHMON_NAME $XMA PRIORITY 030 PERUSE_OBJECT ...

    • XMA:Update all statistics abends with error 1120

      Use the =_SQL_CAT_HEAP_LIMIT, FILE M<nnnn> define to enlarge the default amount of memory (16 MB) that SQLCAT reserves for these kinds of structures. For example, the following DEFINE allows the heap to grow to 128MB: TACL> ADD DEFINE ...

    • XMA: TMF is keeping active transactions open for SLSENDER after SLSENDER and XMA Pathway are stopped

      The reason for this behavior because is the XMA TACL routines are shutting down the pathway with the Pathmon command ?SHUTDOWN2, MODE IM, UNTIL DONE?. The ?MODE IM? means that it stops the servers immediately but does not close them. This allows them ...

    • XMA: how to change HOMETERMs for all the SERVERCLASSes in the Pathway

      Shutdown the pathway -- XMA_PWSTOP to create PWSTATE file Edit the pathway config file -- open PWSTATE file in XMAPW subvol and change the HOMETERMs Cold start the pathway ? XMA_PWCOLD If this article did not provide a solution, please open a case ...

    • XMA: Error 73

      This is a known issue that has been addressed in our current XMA Version 2.65. We therefore recommend upgrading to XMA 2.65 in order to address this error. Softdoc entry for this issue: * XMA-1329 Addresses a latency issue when retrieving messages ...