XMA: how to change HOMETERMs for all the SERVERCLASSes in the Pathway

• Related Articles

• XMA How To Change Ownership On The Existing Installation

  The following methods are available to change the ownership of an XMA environment. Method #1 - Re-Install XMA Procedure: Refer to Chapter 1 " Installing XMA " in the XYGATE Merged Audit (XMA), User's Guide and Reference Manual Method #2 - ...

• XMA: How to Change IP Address of the syslog server using SYSLOGQ

  To change the SIEM IP address use the following to change the IP address in the records stuck in the SySLOGQ table , and update the FILTERS file for future records. TACL> VOLUME $<VOLUME>.<XYGATEMA Installation Subvolume> TACL> RUN XMA INSTALL TACL> ...

• XMA: TMF is keeping active transactions open for SLSENDER after SLSENDER and XMA Pathway are stopped

  The reason for this behavior because is the XMA TACL routines are shutting down the pathway with the Pathmon command ?SHUTDOWN2, MODE IM, UNTIL DONE?. The ?MODE IM? means that it stops the servers immediately but does not close them. This allows them ...

• XMA: Cannot Start $XMA Pathway - Startup attempt fails with no errors

  Check the HOMETERM value in the MACONF file. The MACONF file is found in the XYGATEMA installation subvolume. The HOMETERM value must be a valid / existing home terminal process name. Sample MACONF file: PATHMON_NAME $XMA PRIORITY 030 PERUSE_OBJECT ...

• XMA: Procedure to stop XYGATE Merged Audit when changing system time

  The correct procedure is to stop all pathway serverclasses, including XMA movers and admin servers (HKEEPER, SLSENDER, etc.) using XMA_MANAGER. >run xma install >xma_manager XYGATEMA Management Main Menu v2.60 * * * * * * * * * * * * * * * * * * * 1: ...