XUA: How does IPLOOKUP find the ip address for a session?

• Related Articles

• XUA: NonStop IP address not showing up in monitor dumps / wrong UAGROUP is selected when attempting MFA logon from an SSH session

  This is NOT an XUA issue. This is an issue with older versions of SSH (pre-ACS), which does not provide the ip address. Specifically, because the ip address is not being recorded in the Safeguard audit, there is no ip address to provide to XUA. The ...

• How To Tell If A Terminal Session Is An SSL Session

  1. Get the IP address of the workstation a. Start a DOS command prompt. Where it says "Type here to search" in the lower left corner of the Windows display, enter "command". Example: 2. At the command prompt, enter IPCONFIG. The IPv4 address shown is ...

• XMA: How to Change IP Address of the syslog server using SYSLOGQ

  To change the SIEM IP address use the following to change the IP address in the records stuck in the SySLOGQ table , and update the FILTERS file for future records. TACL> VOLUME $<VOLUME>.<XYGATEMA Installation Subvolume> TACL> RUN XMA INSTALL TACL> ...

• XYPRO GUIs can't connect to the NonStop host after the host ip address is changed

  If the user cannot connect to the NonStop host after the host ip address has been changed, then both XYGATETR (XTR) on the NonStop host and the GUI must be modified to reflect the new ip address 1. If XYGATE/TR (XTR) is configured on multiple NonStop ...

• XMA: How to change old SYSLOGQ entries after updating a SIEM IP address.

  The cleanup commands would remove the data, but to avoid that the customer can use a SQLCI query to update the IP Address in the database itself so all the messages would then be sent to the new IP. It is recommend to run the query below while XMA is ...