XTR: MAKECRT returns cryptlib utcTime error
The file causing this issue is your DSTTABLE file. This is a table created during the NonStop system's installation that tracks changes to and from daylight savings time. This issue occurs when they amount of time in your table is less than the amount of time defined for the SSL certificate.
This file does not have a standard name. To find the file, your NonStop startup files would need to be searched for the TACL command ADDDSTTRANSITION. Your NonStop Administrator should also be able to locate this file as it requires regular maintenance.
This problem would be resolved by using the ADDDSTTRANSITION TACL command to add enough DST transitions to cover the DAYS parameter defined in the SSLCACFG file located in the XYGATETR installation directory.
The syntax for this command is located on page 8-12 of the HP NonStop TACL Reference Manual published August 2013.
If you are unable to locate the solution needed or if you need additional assistance please Click Here to open a case from our Customer Care Portal.
Related Articles
XTR - TRCONF cryptlib error utcTime MIN_STORED_TIME_VAL UE
Verify all the certificate that are available in XYGATETR volume by executing the below command. To verify certificate?s signature, use the following command line options: xycert ?check ?cert:<file> [?cacert:<file>] Command Line Options: -check ...
XTR: MAKECRT error utcTime < N_STORED_TIME_VALUE
Identify if the system is using a daylight savings transition table. TACL> scf info subsys $zzkrn SCF - T9082L01 - (18FEB15) (31OCT14) - 08/09/2016 03:26:08 System \GALAXY (C) Copyright 1986-2014 Hewlett-Packard Development Company L.P. NONSTOP ...
XTR: XYGATETR command socket read error: 4106
This error happens when a non-XTR application attempts to connect to an XTR port. An EMS message with command socket read error: 4106 will show. If you are unable to locate the solution needed or if you need additional assistance, please Click Here ...
XTR: Error encountered when running XTR_SYNTAX_CHECK
Was there a recent XTR install or upgrade? The XTR_FINISH_INSTALL macro may not have been run on completion of the install/upgrade. 1. RUN $<vol>.XYGATETR.XTR INSTALL ($<vol> is the disk volume where XTR is installed) 2. XTR_FINISH_INSTALL If you are ...
XTR: Calamity error 66 displayed during XYGATETR install
A XYPRO support professional can check the Installation/upgrade log for successful installation. If everything looks fine with the installation, error 66 can be ignored. It is helpful to send XTR_SYNTAX_CHECK and XTR_VERSION to XYPRO support for ...