XMA: How to remove/delete RESTSNDR

XMA: How to remove/delete RESTSNDR

The RESTSNDR can be deleted in PATHCOM. Example below:

>Pathcom $XMA 
>INFO RESTSNDR
>DELETE RESTSNDR
>INFO RESTSNDR (confirm no process exists)


If you are unable to locate the solution needed or if you need additional assistance, please Click Here to open a case from our Customer Care Portal.


    • Related Articles

    • XMA: Remove IPRESOLVER Manually

      The IPRESLVER can be removed using the XMA_MANAGER. If you wish to do this manually this is the procedure to do so: 1. Pathcom $xma;freeze IPRESLVR;stop IPRESLVR 2. Pathcom $xma;status server IPRESLVR To make sure IPRESLVR is stopped (it will show a ...

    • XMA: How to uninstall SLSENDER.

      As the SLSENDER is configured and added to the XMA pathway when the customer follows the installation process in the XMA manual. The following procedure can be used to manually stop the SLSENDER , remove any records that have been generated, and stop ...

    • XMA: how to resend XMA alerts when using IPALERT

      Add Alert-Only movers to resend the messages with a FILTER that will not send the records created later than the end DateTime. - The Start DateTime can be specified (e.g. "2022-05-09:00:00:00.000000") when the commands to start the added Alert-Only ...

    • XMA: How to change old SYSLOGQ entries after updating a SIEM IP address.

      The cleanup commands would remove the data, but to avoid that the customer can use a SQLCI query to update the IP Address in the database itself so all the messages would then be sent to the new IP. It is recommend to run the query below while XMA is ...

    • XMA: Measure Mover Keeps Abending

      Is XYPRO SecurityOne installed? The Measure mover is not designed to collect system performance metrics. It is designed to only capture process information for the XYGATE SecurityOne WHO Resolver. The MEASURE mover collects information regarding ...