XMA: How to optimize SLSENDER to handle multiple SIEMs

• Related Articles

• XMA: How to optimize SLSENDER to handle multiple SIEMs for version XMA 2.70 and higher

  SLSENDER must be optimized for the number of SIEMS and transactions 1. SLSENDER can be configured in XMA_MANAGER. >run xma install >XMA_MANAGER >2: Movers >18: Configure SysLog Send server 2. In the SysLog Send server menu (SLSENDER), the Max Number ...

• XMA: How do I optimize SLSENDER to handle multiple SIEMs for version XMA 2.65 or earlier

  SLSENDER must be optimized for the number of SIEMS and transactions 1. SLSENDER can be configured in XMA_MANAGER. >run xma install >XMA_MANAGER >2: Movers >18: Configure SysLog Send server) 2. In the SysLog Send server menu (SLSENDER), the Max Number ...

• XMA: How to uninstall SLSENDER.

  As the SLSENDER is configured and added to the XMA pathway when the customer follows the installation process in the XMA manual. The following procedure can be used to manually stop the SLSENDER , remove any records that have been generated, and stop ...

• XMA: SLSENDER - Steps to follow for SLSENDER When Upgrading to XMA 2.65

  The upgrade to XMA 2.65 makes changes to the SYSLOGQ table. Consequentially, this could cause fatal errors for SLSENDER when it it initially started following the upgrade. This is due to outstanding TMF transactions that remains until they are ...

• XMA: TMF is keeping active transactions open for SLSENDER after SLSENDER and XMA Pathway are stopped

  The reason for this behavior because is the XMA TACL routines are shutting down the pathway with the Pathmon command ?SHUTDOWN2, MODE IM, UNTIL DONE?. The ?MODE IM? means that it stops the servers immediately but does not close them. This allows them ...