How to start a static home terminal

• Related Articles

• XAC: How to configure XAC TACLs for static SSH windows

  Add a static service via the SSH STNCOM utility Example: STNCOM $<process name> (Where $<process name> is the name of a valid STN process, e.g. $ZPTY ADD SERVICE AUDTACL, TYPE STATIC 2. The service added in step #1 will need several static windows ...

• XMA: How do I give a mover a static process name?

  A static process name can be assigned to a serverclass via Pathcom. Follow the steps below: 1. To give a serverclass a static process name: PATHCOM $XMA FREEZE SERVER <serverclass-name> STOP SERVER <serverclass-name> ALTER SERVER ...

• XAC: There will be Open table full if the number of processes opening an XAC terminal exceeds 512

  If possible, use $ZHOME or the NonStop Virtual Hometerm Subsystem (such as $VHS) instead of an XAC terminal.

• XMA: Cannot Start $XMA Pathway - Startup attempt fails with no errors

  Check the HOMETERM value in the MACONF file. The MACONF file is found in the XYGATEMA installation subvolume. The HOMETERM value must be a valid / existing home terminal process name. Sample MACONF file: PATHMON_NAME $XMA PRIORITY 030 PERUSE_OBJECT ...

• How To Tell If A Terminal Session Is An SSL Session

  1. Get the IP address of the workstation a. Start a DOS command prompt. Where it says "Type here to search" in the lower left corner of the Windows display, enter "command". Example: 2. At the command prompt, enter IPCONFIG. The IPv4 address shown is ...